INSTRUCTIONS TO GET TO LVM SCREEN
System:
Candela GentleMax Pro
Laser Service Solutions 650 Grove Road, Suite 104 Paulsboro, NJ 08066
www.laserservicesolutions.com P: 856-853- 7 555 F: 856- 853-7575
To get to the LVM screen on the Candela GentleMax Pro (GMax Pro), you will have to calibrate the laser
for the ALEX and YAG. If you know how to calibrate for both ALEX and YAG, proceed to step six for
instructions on how to go directly to the LVM and what information is needed by the technicians.
You can use whatever handpiece is available but our technicians recommend using a 15mm handpiece.
Step One: Turn key to power the GMax Pro laser and allow to warm up for at least 10 minutes.
Step Two: Your GMax Pro will default to either the ALEX or YAG main screen depending on which setting
you used before turning off the laser. In the center of the main screen will be a circular button and it will
say either ALEX or YAG. Your screen will also be a different color depending on the setting (ALEX is red,
YAG is green).
It does not matter which laser is calibrated first
ALEX SCREEN YAG SCREEN
Step Three: The ALEX and YAG have the same settings. Adjust and confirm that:
DURATION (LEFT BOX): 3ms
RATE (RIGHT BOX): 1.0 Hz
To Next Page
Need help?
General
