Note: The two safety vents are positioned on the back casing, with diameter of
6mm.
4. NOTICE OF INSTALLATION
For safety reason, please use only the
same size of fixing or mounting screw which
are recommended in this instruction manual.
Warning: Failure to install the screws or
fixing device in accordance with these
instructions may result in electrical hazards
1. Before installation, please ensure the area is clean to avoid suction of
the remaining bits of broken wood and dust.
2. It cannot share the same air ventilation tube with other appliance
such as gas tube, warmer tube, and hot wind tube.
3. The bending of ventilation tube should be120°, parallel or above
the start point and should be connected to the external wall.
4. After installation, make sure that the extractor is level to avoid
grease collection at one end.
To Next Page
Loading...
