.22.
Adjusting the height and levelling off your wine cabinet
o The appliance is equipped with adjustable feet, so that the height may
be adjusted to level the cabinet on uneven oor surfaces.
o We recommend that two people carry out this procedure.
o The height must be adjusted prior to building the appliance into the
housing unit and it should be set at such a height that the top panel of
the appliance ts exactly below the kitchen worktop.
o Tilt the appliance approximately 60° to allow access
to the adjustable feet.
o Take care to ensure the cabinet is supported at all
times.
o Twist the foot into a suitable position to level the
cabinet.
o Repeat these steps for the other adjustable feet.
IMPORTANT: If the appliance is not level, then the door and door seal may
be affected.
IMPORTANT: Do not move the appliance when the feet are adjusted high.
Installing The Handle
Gasket
Washer
Handle Screws
Handle
To Next Page
Loading...
