Candy CE 104/1 - SETTING UP INSTALLATION; Initial Placement & Packaging Removal; Removing Transit Brackets; Power Plug Connection & Securing

CHAPTERS
SPITING UP INSTALLATION
Remove the polystyrene base and place the machine near
its permanent position
(diagram I).
Carefully cut through the hose retaining clip at the rear of the
appliance (diagram 2),
Unscrew the central bolt (A); unscrew the 4 lateral screws (B)
and remove the cross piece (C) (diagram 3).
Lean the machine forward and remove the plastic bags
containing the two polystyrene blocks at the sides, pulling
downwards (diagram 4).
Press the plug (to be found In the envelope with the
instructions) Into the hole and rotate to lock Into position
(diagram 5).
1I
WARNING:
DO NOT LEAVE THE PACKAGING IN THE REACH OF
CHILDREN AS IT IS A POTENTIAL SOURCE OF DANGER.