Candy CE 104/1 - SETTING UP INSTALLATION; Water Connection & Drainage Procedures; Machine Levelling Procedure

©
WATER CONNECTION
Your machine may either be plumbed in or connected to
existing taps, using a tap adaptor with a 3 /4 B.S.P. threaded
end connection. The water supply hoses to be found inside
the drum are terminated in two different ways. One end
which has a 90° elbow is to be connected to the appliance
water connection E white the straight end is to be connected
to the domestic supply tap. The hose with the white collar
should be connected to the cold tap, and the hose with the
red cottar to the hot tap. The appliance is not suitable for use
with mixer taps.
Hook the end of the outlet hose over the rim of the sink or
outlet pipe, making sure that it Is not kinked. For better
positioning of the outlet hose make use of the plastic bend
provided.
Where possible, use a fixed discharge pipe with a diameter
greater than that of the outlet hose this allows the air to
escape.
The minimum height of the top of the outlet hose should be 50
cm.
Extending the outlet hose, especially if the extension is more
than J metre, could lead to malfunctioning of the discharge.
The appliance outlet hose should discharge into the foul
water drainage system and not Info the surface wafer
drainage system. Should you require further advice please
contact your local water authority.
Apply the adhesive label supplied in the appropriate
language onto the pull-out wash programme guide (R).
(See chapter 6 - description of control panel).
Level the machine by means of the front feet.
a) Turn the nut clockwise to release the screw adjuster on the
foot.
b) Rotate the foot to raise or lower It until If stands firmly on
the ground.
c) Lock the foot in position by turning the nut anti-clockwise
until it comes up against the bottom of the machine.
Ensure that the ON/OFF button (see page 12, button C) Is not
pressed and the load door is closed.