10
longer than necessary.
4. Do not set temperature any colder than necessary.
5. The direct cooling refrigerator (with a freezer) needs to be defrosted when necessary. This will
improve the cold transfer and reduce energy consumption.
6. The sketch map shows the right combination of the drawers, crisper and shelves which can lead
to the more energy efficiency. If users adjust the combination, it would result in the
energy-consuming.
7. Store food logically. Do not exceed the storage period specified.
Trouble shooting
Correcting Malfunctions
Spare parts:
The following spare parts can be ordered from your local Service Force Center. You can fit these
yourself without any special skill or training, e.g.:
Ice tray,
Ice box,
Drawers,
A malfunction may be caused by only a minor fault that you can rectify yourself using the following
instructions. Do not perform any other work on the appliance if the following information does not
provide assistance in your specific case.
Important!
Repairs to refrigerators/freezers may only be performed by competent service engineers. Improper
repairs can give rise to significant hazards for the user. If your appliance needs repairing, please
contact your specialist dealer or your local Service Force Center.
Symptom Possible Cause Remedy
Appliance is not switched on. Switch on the appliance.
Mains plug is not plugged in or is
loose.
Insert mains plug.
Fuse has blown or is defective. Check fuse, replace if necessary.
Appliance does not work.
Socket is defective. Mains malfunctions are to be
corrected by an electrician.
Appliance cools too much. Temperature is set too cold. Turn the temperature regulator
to a warmer setting temporarily.
Temperature is not properly adjusted. Please look in the “initial Start
Up” section.
Door was open for an extended
period.
Open the door only as long as
necessary.
A large quantity of warm food was
placed in the appliance within the last
24 hours.
Turn the temperature regulation
to a colder setting temporarily.
The food is too warm.
The appliance is near a heat source. Please look in the “installation
location” section.
Heavy build-up of frost,
possibly also on the door seal.
Door seal is not air-tight(possibly
after reversing the door).
Carefully warm the leaking
sections of the door seal with a
hair dryer(on a cool setting). At
the same time shape the
warmed door seal by hand such
that it sits correctly.
Appliance is not level. Readjust the feet. Unusual noises.
The appliance is touching the wall or
other objects.
Move the appliance slightly.
To Next Page
Loading...
