- STEAM LEVEL*
After selecting the EASY IRON programme,
you can use this button to choose between
three steam treatments of different intensities,
designed for dry or wet garments and
depending on the type of fabric:
- COTTON (default selection)
This programme is used for cotton
garments. On wet fabrics (e.g., after
washing), it is suitable for relaxing
creases after spinning; on dry fabrics it
is instead designed to achieve the ideal
humidity level for easier ironing.
- SYNTHETIC (press button once)
This programme is used for synthetic
garments. On wet fabrics (e.g., after
washing), it is suitable for relaxing
creases after spinning; on dry fabrics it
is instead designed to achieve the ideal
humidity level for easier ironing.
- DELICATES (press button twice)
With the help of steam, the cycle
refreshes and relaxes creases in
garments after use. The programme
consists of an initial phase in which the
steam acts and a final phase in which the
excess humidity is removed for immediate
use. The cycle is suitable for dry fabrics.
*STEAM LEVEL
(only available on certain models)
This button allows you to change the
temperature of the wash cycles.
It is not possible to raise the temperature
over the maximum allowed for the
programme, in order to protect the
fabrics.
If you want carry out a cold wash all the
indicators must be off.
By pressing this button, it is possible to
reduce the maximum speed, and if you
wish, the spin cycle can be cancelled.
If the label does not indicate specific
information, it is possible to use the
maximum spin expected in the program.
To reactivate the spin cycle press the
button until you reach the spin speed you
would like to set.
It is possible to modify the spin speed
without pausing the machine.
Pressing simultaneously the buttons
"TEMPERATURE SELECTION" and
"SPIN SPEED" for about 3 seconds, the
machine allows you to lock the keys. In
this way, you can avoid making accidental
or
unwanted changes if a button on the
display is pressed accidently during a cycle.
The key lock can be simply cancelled by
pressing the two buttons simultaneously
again or turning off the appliance.
The machine is fitted with a special
electronic device, which prevents the
spin cycle should the load be
unbalanced. This reduces the noise
and vibration in the machine and so
prolongs the life of your machine.
An over dosing of detergent can
cause excessive foaming. If the
appliance detects the presence of
excessive foam, it may exclude the
spinning phase or extend the duration
of the program and increase water
consumption.
To prevent damage to the fabrics, it is
not possible to increase the speed
over the maximum allowed for the
programme.
TEMPERATURE SELECTION
button
These options must be selected before
pressing the START/PAUSE button.
To Next Page
Loading...
