8
4) Put up the cooker hood and lock it
with the explosion screw on the ceiling
IMPORTANT: This stage of the
installation process MUST be
completed by two people.
5) Put up the upper chimney and fix by
six screws.
.
The electrical connection must correspond to the electrical requirement
noted on the rating plate, which is placed inside the cooker hood. The
appliance should now be connected to the electrical supply.
Check that the appliance is operating correctly by selecting each speed and
switching the light bulbs on and off.
Use a stainless steel cleaner and polish on the stainless steel sections of the
appliance.
If you are using the appliance in recirculation mode, then
you
should now fit
the carbon filter. See the “fitting the carbon filter" section on page 6.
NOTE: If Low / Medium / High speed buttons are press at the same
time, the unit will only operate at the highest speed.
To Next Page
Loading...
