Function introduction
1. Keys
А. Hi Humidity: High Humidity Mode
В. ON/OFF: start up оr shut down the system
С./\: increase temperature of the cooling chamber
D.
V:
decrease temperature of the cooling chamber
2. Names of functions of display screen
1,
High Humidity figure
2,
Temperature region digitron
3,
Temperature
(°С)
figure
3. Display control
•
Power on for the first time: all shines for three seconds with ringing of start bell.
Defaulting temperature of the cooling chamber is 5°C.
•
Normal operation display:
Temperature display region: when there is а failure, it will show failure codes bу turn
at а priority order; without failure, it will show the set temperature.
High Humidity figure: shine when the system is under High Humidity Mode.
•
Display control:
1,
Under the normal pattern, it will not shine апу more after thirty seconds without
opening and key operation;
2,
When the door is under ореn state, the display will shine all the time and it will
stop shining thirty seconds after the door is closed.
3,
When а failure happens and it is within "Failure Code", the screen will shine for
one time and stop to shine after thirty seconds (if the buzzer has been ringing for
а long time, press any key to cancel the failure bell);
4. User Mode operation
•
Start-up and shutdown
Under start-up mode, press and hold ON/OFF key (В key) for three seconds, the
start bell will ring and the system will bе shut down immediately;
Under shutdown mode, press and hold ON/OFF key (В key) for three seconds, the
start bell will ring and the system will bе started immediately.
Press ON/OFF key for three seconds to shut down the system and the display screen
will not show any more. Except ON/OFF key (В key), other keys will stop
responding, and compressor, door lamp and other loads will bе shut down
immediately;
Press ON/OFF key for three seconds to start up the system. Before starting, if the
To Next Page
Loading...
Need help?
General
