Why Candy CO 4104TWM/1-S Washer does not work / start?
If your Candy Washer doesn't start, please check the following: * Ensure the washer is plugged into a working supply socket. * Verify that the power is on. * Test the wall socket with another appliance. * Make sure the door is correctly closed. * Confirm the correct program is selected and the start button is pressed. * Ensure the washing machine is not in pause or time delay mode.
What to do if water leaked on the floor near my Candy CO 4104TWM/1-S?
If you notice water leaking near your Candy Washer, it could be due to: * A leak from the seal between the tap, supply hose, and fill valve. Replace the seal and tighten the hose connections correctly. * The front filter not being correctly closed. Make sure it is properly secured.
Why Candy Washer does not spin?
If your Candy Washer isn't spinning, here's what to check: * Remove the load, de-tangle it, reload it, and restart the spin program. * Wait a few minutes to see if the water drains completely. * Ensure the "no spin" function is not selected. * Check the selected options and their impact on the spin cycle. * Verify that you're using the correct amount of detergent, as excessive detergent can impede the spin cycle.
What to do if my Candy CO 4104TWM/1-S displays E3 or 3 flashes?
If your Candy Washer displays error code E3 or 3 flashes, check the following: * Ensure the filter is not clogged and there are no foreign objects inside the filter compartment obstructing water flow. * Make sure the drain hose isn’t bent, kinked, or trapped. * Verify the home drainage system is not blocked.
What to do if my Candy CO 4104TWM/1-S has strong vibrations / noises during the spin cycle?
If you hear strong vibrations or noises during the spin cycle of your Candy Washer, consider these points: * Ensure the washing machine is fully leveled. * Verify that transport screws, rubber bungs, and spacer tubes were removed. * Check for any foreign objects inside the drum, such as coins, hinges, or buttons.
What to do if my Candy CO 4104TWM/1-S Washer displays E7 or 7 flashes?
If your Candy Washer shows error code E7 or 7 flashes, try these steps: * Ensure the door is correctly closed and that clothes inside the drum are not preventing it from closing fully. * If the door is locked, turn off and unplug the washing machine, wait 2-3 minutes, and then reopen the door.
What to do if my Candy CO 4104TWM/1-S displays E2 or 2 flashes?
If your Candy Washer displays error code E2 or 2 flashes, consider the following: * Ensure the water supply tap is open. * Check that the water supply hose isn’t bent, kinked, or trapped. * Verify the drain pipe is at the proper height. * Close the water supply tap, unscrew the filler hose, and clean the “anti-sand” filter. * Check that the filter is not clogged.
What to do if my Candy Washer displays E4 or 4 flashes?
If your Candy Washer displays error code E4 or 4 flashes, ensure the correct amount of detergent is being used and that the detergent is designed for use in a washing machine.
To Next Page
General
