NOTE:
• Make sure the filter is securely locked. Otherwise, it would loosen and cause
dangerous.
• When activated carbon filter attached, the suction power will be lowered.
BULB REPLACEMENT
Important :
The bulb must be replaced by the manufacturer, its
service agent or similarly qualified persons.
Always sw itch o ff t he el ectricity supply b efore
carrying out any operations on the appliance. Wh
en
handling bulb, make sure i t is completely cool down
before any direct contact to hands.
When handling globes hold with a cloth or gloves to
ensure p erspirati
on does n ot com e in con tact w ith
the globe as this can reduce the life of the globe.
LED LIGHTS:
• Switch the unit off and pull out the plug first.
• Wait until the light bulb is cooled down before replacement.
• Remove the front part with the aid of screwdriver.
• Pull out the LED light carefully and replace with the same type and rated LED light
(2*2W LSD-B2 LED light)
• Replace the front part back to the unit with screwdriver.
• ILCOS D code for this lamp is: DBR-2/65-H-64
– LED modules, self- ballasted – round lamp
– Max wattage: 2 W
– Voltage range: AC 110-240V
– Dimensions:
To Next Page
Loading...
