54 -
The hob does not operate.
The hob does not cut off
The hob stops automatically
Frequency of on/off operations
for cooking zones
“H” display, residual heat
indicator, blinking
• A big spill or object covers at least two buttons, for
at least 10 seconds. Clean up the spill or remove
the object.
• The control panel is locked. Press the “Locking”
button to release.
• The control panel is locked. Press the “Locking”
button to release. Refer to the section, “Operating
time” page 49.
• A spill covers at least two buttons for more than
10 seconds; the hob switches to safety, and an au-
dible beep sounds so long as the buttons are cov-
ered. Clean up the spill or remove the object.
• The cooking zones stop automatically if they are
left on for too long. Refer to the section, “Operating
time” page 49.
• The on-off cycles vary according to the required
heat level:
- low level: short operating time,
- high level: long operating time.
• The electronic temperature is too high. A techni-
cian should verify the fitting in compliance with the
recommendations, page 41 & 42.
PROBLEMS AND SOLUTIONS
To Next Page
Loading...
