Why is my Candy Ranges machine completely dead?
Your Candy Ranges machine might be completely dead due to several reasons: the plug may not be connected correctly (connect electric plug), the O/I button may not have been pressed (press button), there may be no electricity (check the electricity supply), or the door could be open (close door).
What to do if my Candy TRIO 9503 machine does not draw water?
If your Candy Ranges machine isn't drawing water, check if the water tap is turned off (turn water tap on), ensure the programme selector is in the correct position (turn programme selector to correct position), make sure the inlet hose isn't bent (eliminate the bends in the hose), and verify that the inlet hose filter isn't blocked (clean the filter at the end of the hose).
Why does my Candy Ranges machine not discharge water?
Your Candy Ranges machine may not be discharging water because the filter is dirty (clean filter), the outlet hose is kinked (straighten outlet hose), or the outlet hose extension is not correctly connected (follow the instructions for connecting the outlet hose carefully). If the outlet connection on the wall is pointing downwards not upwards, call a qualified technician.
Why is there noise during wash with my Candy TRIO 9503 Ranges?
Noise during a wash cycle in your Candy Ranges could be because the dishes are knocking against one another or the revolving arm is hitting the dishes. To resolve this, load dishes better onto the basket.
Why does my Candy TRIO 9503 machine discharge water continuously?
If your Candy Ranges machine discharges water continuously, it is likely that the position of the outlet hose is too low. Lift the outlet hose to at least 40 cm above floor level.
Why are my dishes not completely dry in Candy Ranges?
If the dishes are not completely dry in your Candy Ranges, it may be due to inadequate air flow. Leave the dishwasher door ajar at the end of the wash program to allow dishes to dry naturally.
Why is the spray arm not heard to rotate in my Candy TRIO 9503?
The spray arm in your Candy Ranges might not be rotating because of an excessive amount of detergent (reduce amount of detergent), an item preventing the arm from rotating (check), or a very dirty plate and cup filter (clean plate and cup filter).
What does it mean when the "Eco" indicator light and indicator light "No 1" are on with an audible signal on my Candy Ranges?
If the "Eco" indicator light and indicator light "No 1" are on with an audible signal on your Candy Ranges appliance, it indicates that the water inlet tap is turned off. To resolve this, switch off the appliance, turn on the tap, and reset the cycle.
Why is there presence of white spots on dishes from my Candy Ranges?
The presence of white spots on dishes from your Candy Ranges may be due to the water being too hard. Check the salt and rinse aid level and regulate the amount. Should the fault persist, contact Service Centre
What to do if my Candy TRIO 9503 load of dishes is only partially washed?
If your Candy Ranges load of dishes is only partially washed, it could be due to several reasons. The bottom of saucepans may not have been washed well (burnt on food remains must be soaked before putting pans in dishwasher), the edge of saucepans may not have been washed well (reposition saucepans), the spray arm may be blocked (remove spray arm by unscrewing ring nut clockwise and wash under running water), the dishes may not have been properly loaded (do not place the dishes too closely together), the end of the outlet hose may be in the water (the end of the outlet hose must not come into contact with the outflow water), the incorrect amount of detergent has been measured out or the detergent is old and hard (increase the measure according to how dirty the dishes are and change deterge...
Details safety measures for children, proper usage environments, door hazards, sharp utensil handling, and basic appliance operation.
Addresses hazards from hot surfaces, cooking with fat/oil, fire prevention, and warnings about storing items on the hob.
Covers general installation warnings, specific notes for gas models, and important reminders about gas setting modifications.
Details regulations and methods for gas connection, including rigid pipe, flexible hose, and soft rubber options.
Outlines essential safety checks, warnings, and general procedures for electrical connections.
Provides an overview of the dishwasher controls and the procedure for selecting wash programmes and functions.
Details the correct loading of detergent, filling the rinse aid dispenser, and loading dishwasher salt for effective cleaning.
Lists essential safety measures and precautions to follow before cleaning any part of the appliance.
A comprehensive guide listing common dishwasher faults, their causes, and recommended solutions for self-resolution.
To Next Page
General
