Why is my Candy Ranges machine completely dead?
Your Candy Ranges machine might be completely dead due to several reasons: the plug may not be connected correctly (connect electric plug), the O/I button may not have been pressed (press button), there may be no electricity (check the electricity supply), or the door could be open (close door).
What to do if my Candy TRIO 9501 Ranges machine does not draw water?
If your Candy Ranges machine isn't drawing water, check if the water tap is turned off (turn water tap on), ensure the programme selector is in the correct position (turn programme selector to correct position), make sure the inlet hose isn't bent (eliminate the bends in the hose), and verify that the inlet hose filter isn't blocked (clean the filter at the end of the hose).
Why does my Candy TRIO 9501 machine not discharge water?
Your Candy Ranges machine may not be discharging water because the filter is dirty (clean filter), the outlet hose is kinked (straighten outlet hose), or the outlet hose extension is not correctly connected (follow the instructions for connecting the outlet hose carefully). If the outlet connection on the wall is pointing downwards not upwards, call a qualified technician.
Why is there noise during wash with my Candy TRIO 9501?
Noise during a wash cycle in your Candy Ranges could be because the dishes are knocking against one another or the revolving arm is hitting the dishes. To resolve this, load dishes better onto the basket.
Why does my Candy TRIO 9501 machine discharge water continuously?
If your Candy Ranges machine discharges water continuously, it is likely that the position of the outlet hose is too low. Lift the outlet hose to at least 40 cm above floor level.
Why are my dishes not completely dry in Candy TRIO 9501?
If the dishes are not completely dry in your Candy Ranges, it may be due to inadequate air flow. Leave the dishwasher door ajar at the end of the wash program to allow dishes to dry naturally.
Why is the spray arm not heard to rotate in my Candy Ranges?
The spray arm in your Candy Ranges might not be rotating because of an excessive amount of detergent (reduce amount of detergent), an item preventing the arm from rotating (check), or a very dirty plate and cup filter (clean plate and cup filter).
What does it mean when the "Eco" indicator light and indicator light "No 1" are on with an audible signal on my Candy TRIO 9501?
If the "Eco" indicator light and indicator light "No 1" are on with an audible signal on your Candy Ranges appliance, it indicates that the water inlet tap is turned off. To resolve this, switch off the appliance, turn on the tap, and reset the cycle.
Why is there presence of white spots on dishes from my Candy TRIO 9501?
The presence of white spots on dishes from your Candy Ranges may be due to the water being too hard. Check the salt and rinse aid level and regulate the amount. Should the fault persist, contact Service Centre
What to do if my Candy Ranges load of dishes is only partially washed?
If your Candy Ranges load of dishes is only partially washed, it could be due to several reasons. The bottom of saucepans may not have been washed well (burnt on food remains must be soaked before putting pans in dishwasher), the edge of saucepans may not have been washed well (reposition saucepans), the spray arm may be blocked (remove spray arm by unscrewing ring nut clockwise and wash under running water), the dishes may not have been properly loaded (do not place the dishes too closely together), the end of the outlet hose may be in the water (the end of the outlet hose must not come into contact with the outflow water), the incorrect amount of detergent has been measured out or the detergent is old and hard (increase the measure according to how dirty the dishes are and change deterge...
Guidance for optimal appliance use, safety, and essential pre-installation points.
Key specifications, dimensions, and model details of the appliance.
Procedures for installing the gas model, including gas connection requirements.
Details on different methods for connecting the gas supply securely.
Instructions for adapting the appliance to different gas types and changing burner jets.
Procedure for adjusting the minimum gas burner flame for optimal performance.
Detailed steps and safety precautions for connecting the appliance to electricity.
Specific electrical connection guidance for Trio 9501 and Trio 9503 models.
How to connect water supply and set up the drainage system for the appliance.
Instructions for operating the gas burners, including lighting and flame control.
Guidelines for using the vitroceramic zones and selecting appropriate cookware.
How to use oven shelves, drip trays, and other accessories for cooking.
Instructions on various oven cooking methods and preheating requirements.
Advice for cooking different types of meat, including preparation and timing.
Overview of the dishwasher's control buttons and indicator lights.
How to choose and set programmes, including special functions.
Instructions for starting, opening, closing, and interrupting dishwasher cycles.
How to save the last used dishwasher programme.
Procedure for cleaning and maintaining the dishwasher's filter system.
Guidelines for correct dish loading to ensure optimal wash results.
Instructions for loading detergent and filling/regulating the rinse aid dispenser.
How to load salt into the dispenser for water softening.
How to adjust the water softener based on water hardness levels.
Information on different washing programmes, including energy and water consumption.
Practical advice for achieving better washing results and efficient operation.
What to do if you need to stop the dishwasher mid-cycle.
List of items and materials that should not be washed in the dishwasher.
Instructions for cleaning enameled parts of the appliance without damage.
Procedures for cleaning the hob, oven lighting, accessories, door glass, and door.
How to clean the gas burners and the hob lid safely and effectively.
To Next Page
General
