Cane Creek HELLBENDER 70 User Manual

INSTALLATION GUIDE | IS ASSEMBLIES
1
CONFIRM MEASUREMENTS
WWW.HEADSETFITFINDER.COM
2
PREPARE FRAME & FORK
WWW.CANECREEK.COM/TECH-CENTER
INSTALL AND ASSEMBLE HEADSET PARTS
WWW.CANECREEK.COM/TECH-CENTER
3
PROFESSIONAL FRAME PREPARATION AND HEADSET
INSTALLATION RECOMMENDED.
PROFESSIONAL FRAME VORBEREITUNG UND HEADSET-
INSTALLATION EMPFOHLEN
LA PREPARAZIONE PROFESSIONALE E L’INSTALLAZIONE
TELAIO AURICOLARE RACCOMANDATO
LA PRÉPARATION DU CADRE PROFESSIONNEL ET
L’INSTALLATION CASQUE RECOMMANDÉ
1.1 - 1.7 Nm
#1
#2
4
TIP:
A LITTLE WATERPROOF GREASE ON THE CROWN RACE SEAL AND TOP COVER SEAL
WILL KEEP EVERYTHING TURNING SMOOTHLY.
ADJUST HEADSET
WWW.CANECREEK.COM/TECH-CENTER
Pre-Load Bolt
Top Cap
Stem
Bearing
Star-Nut
Crown-Race
Bearing
Top-Cover
Assembly
Spacers
(if applicable)
Cane Creek Cycling Components | 355 Cane Creek Rd, Fletcher, NC 28732 | 800.234.2725 | info@canecreek.com | canecreek.com
準備專業的車架及建議組裝的車頭碗

Cane Creek HELLBENDER 70 Specifications

General

Upper Stack Height	9mm
Type	Integrated
Color	Black
Material	Aluminum
Crown Race Material	Aluminum
Steerer Tube Diameter	1-1/8"
Lower Bearing	36x45°