21
Figure 2.1: Fix the cot to the side support and fasten all zippers on the cot. Figure 2.2: Place the
mattress on the bottom of the cot. Figure 2.3: Install the storage basket. Figure 2.4: The cot is
fully installed and ready to be used.
3.HEIGHT ADJUSTMENT OF THE COT – ILLUSTRATION 3:
Figure 3.1: Press the button (1) and pull up the handle (2). Figure 3.2: After completing the
above operations: To adjust the cot in higher position, drag the handle up and so moving the
cot in higher position. To adjust the cot in lower position, drag the handle down and so moving
the cot in lower position.
4. LOWERING THE DROP SIDE – ИЛЮСТРАЦИЯ 4:
Figure 4.1: Open the zippers on both sides.
Figure 4.2: Press in the direction of marked arrow.
Figure 4.3: Remove the ends of the guardrail.
Figure 4.4: Roll the fabric around the drop side top rails and fix it.
Figure 4.5: The cot is ready.
5. ATTACHING THE CRIB TO THE ADULT'S BED – ILLUSTRATION 5:
Thread the belts under and over bed’s mattress, buckle them and tighten.
When the height of the crib is in level 1, the seat belt is fixed on the side of the bed as shown in
Figure 2. When the height of the crib is in level 7, the seat belt is fixed on the side of the bed as
shown in Figure 1. When the height of the crib is in level 2-6, the seat belt is fixed on the side of
the bed as shown in Figure 3.
6.HOW TO USE THE STOPPER– ILLUSTRATION 6:
Figure 6.1: To engage the stopper and lock the casters, press down on the caster plate. To
release the stopper, lift the plate up.
Figure 6.2: When fixing a cot to the parent's bed: make sure the cot legs reach the side board of
the adult's bed as shown in figure a. Then operate the stopper and lock the wheels as shown in
figure b.
7.HOW TO INSTALL MOSQUITO NET– ILLUSTRATION 7:
Fix the mosquito clip to the guardrail tube both sides and then unfold the net well to cover the
crib.
Clean the plastic or metal parts of the product with a soft cotton cloth or sponge moistened with
water or a mild detergent. Do not use bleach, agressive detergents or abrasive products to clean
the product. All textile parts and fabrics should be washed only by hand, following the
instructions on the label. After cleaning, allow the crib to dry well before using it. Do not fold or
remove the crib before it is completely dry. Do not expose the product to direct sunlight for
extended periods of time and to extreme temperatures that may change color and damage
exposed parts. After prolonged exposure to high temperatures, wait a few minutes before
placing the child in it. Do not place objects in or on the product to avoid damaging the structure
and / or upholstery. Store the product in a clean and dry place.
Manufactured for Cangaroo in PRC, Manufacturer and Importer: Moni Trade Ltd.
Address: Bulgaria, Sofia, Trebich, 1 Dolo Str., Phone number: 003592/936 07 90,
Website: www.cangaroo-bg.com
To Next Page
Loading...
