14
TROUBLESHOOTING
Question Answer
Water is leaking from the device.
You may have put too much water. Do not pour more than the
recommended quantity of water in the reservoir.
White spots on the water
reservoir, the sterilizing body, the
tray or the lid
Deposition of lime scale is normal and it happens faster in the
areas with more hard water. Clean the device regularly from the
lime scale.
Too much steam comes out from
the lid.
Check if the lid is placed correctly on the tray.
The sterilizing process takes too
much time.
You may have poured too much water in the sterilizer. The actual
sterilizing time is determined by the numbers of the articles in the
tray and the quantity of water.
The sterilizing process takes
short time.
You may have put less water in the sterilizer.
B. DESCALING:
1. Pour 100 ml of vinegar and 200 ml of cold water into the reservoir in the base of the
appliance. Leave the solution until the lime scale dissolves. After that pour out the solution and
rinse thoroughly the reservoir. Leave the appliance to dry out before take it away for storage.
OR:
2. Mix one sachet with citric acid (10 gr) with 200 ml of water. Pour the solution in the reservoir
in the base of the device. Turn on the sterilizer and leave it to heat the solution for 1 ā 2
minutes.
After that turn off and leave the device to cool out for about 30 minutes. Drain the solution and
rinse thoroughly the inner part of the reservoir and wipe dry.
Manufactured for CANGAROO
Importer: Moni Trade LTD
Address: Bulgaria, Sofia, quarter Trebich, Dolo str. No. 1
Tel.: 00 359 2/ 936 07 90
To Next Page
Loading...
