24
Step 3: Lift the cover of head support and pull the shoulder belts at front to remove them.
Press the roation button to rotate the child seat to 180° или 360°. The seat is rotatable in both directions. By fixing in
required position (car seat FORWARD facing or REARWARD facing) you will hear a click sound.
Pull the lever for recline and set the seat un required position as follows (see Figure I for reference):
• Rearfacing seat: Five possible recline positions for the seat as shown in Figure I.1.
• Forward-facing seat: Five possible recline positions as shown in Figure I.2.
Installation with ISOFIX and support leg (rearward facing).
Use the chair's 5-point safety harness to ensure your child's safety.
1. Place the car seat on vehicle seat, install ISOFIX attachment, fix the support leg to the floor.
2.Place the child in car seat, put and lock the 5-point safety harness.
3. Press the lever and rotate the seat, so that it faces the backrest of vehicle seat (child is rearward facing).
Installation with ISOFIX and support leg (forward facing).
Use the chair's 5-point safety harness to ensure your child's safety.
1. Place the car seat on vehicle seat, install ISOFIX attachment, fix the support leg to the floor.
2.Place the child in car seat, put and lock the 5-point safety harness.
3. Press the lever and rotate the seat, so that it faces the direction of vehicle traffic (child is forward facing).
Installation with ISOFIX and 3-point safety belt (forward facing) – figure L.1.
1.Store the support leg under the base.
2.Install ISOFIX attachments to ISOFIX slots at vehicle.
3.Place the child in the car seat and set the height of head support based on the child’s height.
4.Pull the 3-point safety belt of vehicle.
5.Thread the diagonal belt though the guide of head support, and the lap through the guide of base and lock them
into the vehicle buckle.
Installation with 3-point safety belt (forward facing) – figure L.2.
1.Store the support leg under the base.
2.Place the child in the car seat and set the height of head support based on the child’s height.
3.Pull the 3-point safety belt of vehicle.
4.Thread the diagonal belt though the guide of head support, and the lap through the guide of base and lock them
into the vehicle buckle.
❖ MAINTENANCE
1. Regularly check the locking, fixing and adjusting mechanisms, the belts and cover, in order to make sure that they are in
good working order, not worn or damaged and their use is safe.
2. If you find any fault or that any of the functions does not work, stop using he car seat.
3. The car seat must not be used without cover! It is integral part of the car seat and can be replaced only with an identical
one to the one provided by the manufacturer.
To Next Page
Loading...