Need help?Do you have a question about the Cannon HTHS Series II and is the answer not in the manual?
General| Brand | Cannon |
|---|---|
| Model | HTHS Series II |
| Category | Measuring Instruments |
| Language | English |
Describes the purpose of the HTHS Series II viscometer for testing oils.
Outlines the topics covered in the instruction and operation manual.
Details the key physical components of the HTHS Series II viscometer.
Lists crucial safety procedures and precautions for operating the HTHS Series II.
Details the main parts and their functions within the HTHS Series II.
Briefly describes the sample introduction and test process.
Details protective housing, pressure relief, and thermostat functions.
Provides the model name, physical dimensions, and weight of the viscometer.
Specifies environmental requirements, compliance, and fuse replacement.
Lists available Newtonian viscosity standards for calibration.
Steps for unpacking and verifying the contents of the shipment.
Procedures for handling and reporting any damaged components.
Step-by-step guide for physically setting up the HTHS unit.
Instructions for connecting the syringe hose adapter for vacuum/pressure.
Guide for connecting the regulated nitrogen gas supply.
Steps to verify the instrument is properly powered and ready.
Procedure to check the functionality of the Vacuum Pressure Unit.
Verifies the nitrogen supply is connected and functioning.
Tests the solenoid valves for proper operation and pressure control.
Describes the capabilities of the viscosity calculation software.
Lists minimum specifications for running the HTHS software.
Guides the user through installing the viscosity calculation software.
Details how to configure the software with calibration data.
Prepares the unit and sample for running HTHS tests.
Details the use of plug valves during sample preparation.
Steps for flushing the cell with rinse oil before sample testing.
Procedure for allowing the oil sample to reach equilibrium temperature.
Precisely regulates the oil volume in the viscometer tube before testing.
Guides through the actual process of running a sample test.
Recommends flushing cells daily to prevent clogging.
Steps to diagnose and clear blockages in capillary tubes.
Detailed steps for cleaning the capillary tube, including disassembly.
Details how to remove obstructions from the capillary tube.
Describes the use of CANNON-manufactured oil standards for calibration.
Information on capillary specifications and the Cell Calibration Record.
Provides important notes on shear rate and sample residue for calibration.
Lists part numbers and their corresponding descriptions for replacement.
Details the warranty coverage for the HTHS Series II instrument.
Outlines the warranty for reagents and chemicals.
Procedures and requirements for returning the instrument for service.
Procedure for replacing a capillary tube in the HTHS test cells.
Lists necessary tools and replacement parts for capillary replacement.
Steps to safely remove the viscometric cell from the instrument.
Steps for disassembling the viscometric cell.
Detailed steps to carefully remove the capillary from the cell.
Procedure for reassembling the viscometric cell after capillary replacement.
Procedure for replacing the rupture disc assembly.
Steps for installing the new rupture disc assembly.
Recommendations for routine replacement of the rupture disc.
Diagram illustrating the construction of the plug valve.
Cutaway view showing the viscometric cell and exit capillary assembly.
To Next Page
