leans a little. To verify that it is empty, lift up and drain all water from the floater, then place
back in spa and see if it flips completely.
-Shock once per month or when water is hazy. Use a capful of the oxidizing non-chlorine
shock, also known as monopersulfate.
-After 4 months replace the top half.
-Test weekly and adjust levels accordingly. A bottle of 30 test strips is included.
-Change water every 4 months. We recommend using Brilliance Jet Cleanse prior to
draining the water to thoroughly clean the plumbing of organics/biofilm.
*More info can be obtained on www.frogproducts.com/product/atease_floating_system/ and
there are detailed instructions in the box.
Other Water Chemistry Tips
pH: Keep within 7.2 – 7.6
If it is too low, the surface of the shell may become etched. To fix, add pH increaser.
If it is too high, scale forms of the shell, water can become cloudy, and it can compromise
equipment. To fix, add pH decreaser.
Alkalinity: Keep within range 80 – 120 ppm
If it is too low, there is no buffer, causing the pH to fluctuate. To fix, add alkalinity increaser
If it is too high, the water will become cloudy. To fix, add muriatic acid.
Hardness: Keep within range 150 - 250 ppm
If it is too high, scale (calcium) will form on the shell and in the mechanicals. To fix, dilute
water.
Metals: You do not want metals present in the spa water (except silver). Either use a pre-carbon filter on
the fill hose or add a metal sequestrant agent such has Brilliance metal and scale control.
Foam: Ensure air controls are in the off position when not in use. Avoid lotions and detergents on
bathing suits. Use Brilliance defoamer if needed. Worst case scenario, drain ½ the water.
Spa Filter Settings: When spa runs on pump 1, low speed to circulate water
through filter(s) and emit ozone + other topside control functions
Filter start time is whenever the spa was last powered up, and 12 hours later a 2nd cycle
You can change duration of each cycle to 2 hours (F2, factory set), 4 hours, F4, F6, F8, or C (continuous)
To program, press Warm or Cool then Jets. Press Warm to adjust. Press Jets to exit.
Mode is changed by Warm or Cool then Light. You want to be in Standard (ST), not Economy or Sleep
What are the dials around the spa perimeter?
-medium dials control the air flow. When on, it makes the jets feel much stronger.
-large dial (not on TT150, 250, or 350) divert the water from each pump(s) to various seats.
-Massage can be customized via pump speed, large pump dial, air control, and individual jets
*We appreciate you choosing Cannon Pools and Spas. All future chemicals will now be 10% off if
you mention you own a “Cannon” spa at the register.
2 of 2
To Previous Page
Loading...