Canon FT QL - Checking Correct Film Loading; Setting the Film Speed

Checking Correct Film Loading
The film is properly loaded and advanced if the film rewind
crank rotates when you wind the film advance lever. If
the rewind crank does not rotate, take out the film, as
explained on the following page, and reload.
Setting the Film Speed
When loading the film, be sure to set the film speed
scale at the proper position. Refer to page 16 for setting
the film speed.
■ When repacking a long-wound film for darkroom loading
into an ordinary cartridge, be sure to trim the tip of the
leader between perforations.
27