● If you set to <On>, the setting will become effective with next replacement of toner cartridges.
● Immediately after cartridge replacement, a certain amount of time is required for toner to be evenly
distributed inside the cartridge.
<Remove Streaks from Orig. Scanning Area>
You can congure a setting to prevent stains from being scanned when they are detected in the document feed
scanning area. Selecting <On> removes streaks generated by the edge of the original.
<Off>
<On>
<Menu>
<Adjustment/Maintenance>
<Adjust Image Quality>
<Remove Streaks from Scan
Area>
Select <Off> or <On>
● When streaks are removed, areas with stains are not scanned. Clean the original scanning area so that the
original is scanned satisfactorily.
Setting Menu List
483
To Next Page
Loading...
