What to do if I unplug Canon imagePROGRAF iPF6300S Basic Guide No.3 Printer before it is off?
What to do if you accidentally unplug your Canon Printer before it's fully off? If this happens, plug the printer back in, reinstall the ink tanks, and then repeat the entire transfer preparation procedure.
Why should I not remove Maintenance Cartridge from Canon imagePROGRAF iPF6300S Basic Guide No.3 Printer?
Why you shouldn't remove the Maintenance Cartridge during the Canon Printer's process? It's crucial to keep the Maintenance Cartridge in place throughout the process to prevent ink from leaking out.
How to prepare Canon imagePROGRAF iPF6300S Basic Guide No.3 for transfer with Maintenance Cartridge error?
How to prepare Canon Printer for transfer if the display asks to replace Maintenance Cartridge? You must replace the Maintenance Cartridge before starting transfer preparations. Ensure you have a new Maintenance Cartridge available.
What to do if Canon imagePROGRAF iPF6300S Basic Guide No.3 Printer shows 'Consumables must be replaced'?
What to do if Canon Printer displays 'Consumables must be replaced. Call for service.'? Press the OK button and contact your Canon dealer for assistance.
Why is my Canon imagePROGRAF iPF6300S Basic Guide No.3 not cutting paper?
Your Canon Printer might not be cutting paper because the printed document is caught on a foreign object by the Output Tray, which lifted the document, causing the Cutter to pass under the paper. Remove any foreign objects by the Output Tray to allow the printer to properly eject the printed document. Alternatively, check the printer driver settings for Auto Cut and ensure that 'Yes' is selected. Also, verify that the Cutting Mode is not set to Eject or Manual in the Control Panel menu. If it is set to Eject, press the Cut button. If set to Manual, use scissors to cut the paper.
How to fix Canon imagePROGRAF iPF6300S Basic Guide No.3 Printer when paper is not cut neatly?
If the paper is not being cut neatly by your Canon Printer, it could be due to several reasons. First, the paper might be bent or curled at the cut position; straighten out any curling at the edges. Second, the paper might be rising at the ends of the cut position before being cut; try reloading the paper correctly. Also, you may be using paper that cannot be cut with the Cutter Unit.
What to do if roll paper cannot be inserted into the paper feed slot of Canon imagePROGRAF iPF6300S Basic Guide No.3?
If you're having trouble inserting roll paper into the paper feed slot of your Canon Printer, it could be due to a few reasons. The roll paper might be warped; try to straighten out any curls before reloading it. Alternatively, paper might be jammed in the paper feed slot; remove any jammed paper. It's also possible that after advancing a roll, the paper was manually pulled out, closing the Paper Feed Slot; in this case, remove the roll and open the paper feed slot.
Why is there a depression on the leading edge of paper from my Canon imagePROGRAF iPF6300S Basic Guide No.3?
A depression on the leading edge of paper from your Canon Printer may occur if a roll remains in the printer for an extended period without being printed on. To prevent this, especially when printing quality is important, consider setting TrimEdge Reload to On or Automatic. This will automatically cut the paper edge before printing.
To Next Page
General