Do note that all 4 horizontal beams are to be horizontal and aligned (please see
Fig 1 that shows wrong alignment). At the 4 corners of the horizontal beams, we
have designed the beam when installed has a small gap to allow for expansion of
the wood.
While installing the horizontal beams & ensuring the consistency of the gap at all
four corners, it may be necessary to loosen the bolts, make the adjustment to
achieve a consistent gap at all 4 corners before tightening the bolts again.
Important notes:
1) Adjustment must be made prior to the installation of the roof &
2) Do not over torque the mounting bolts. Over torqueing the bolts will crush the
Cedar wood.
1
7
ASSEMBLY
Fig. 1
Fig. 2
Fig. 3