9
CARE AND MAINTENANCE
OPERATING INSTRUCTIONS
9
Timer Setting
The timer mode shoud be used to set the countdown for the unit’s main power.
Press the up arrow button or down arrow button to adjust the timer setting from 0 hour (OFF) to 9 hours
with 0.5 hour intervals.
Flame Brightness Setting
The flame brightness mode is used to set the flame brightness.
Use the up arrow button or down arrow button to scroll through the flame brightness settings: F0 (flame off,
lowest brightness of ember bed), F1, F2, F3, F4, F5 (brightest).
Up Arrow Button
Use up arrow button to increase the setting of the selected function.
Down Arrow Button
Use down arrow button to decrease the setting of the selected function.
Child Lock
Activate Child Lock
When the unit is ON, hold the POWER button for 10 seconds to activate the child lock function. E3 will be
displayed and the unit will beep 3 times indicating that the child lock function is activated. All function keys
are locked. When any button is pressed, E3 will show on the display indicating that the child lock function is
activated.
Deactivate Child Lock
To deactivate the child lock function, hold the POWER button for 10 seconds.
Note: The child lock function is only available if using the control panel.
Care and Maintenance
Make sure the unit is turned OFF, unplugged and the heating elements of heater are cool whenever you are
cleaning the heater.
Clean the metal trim using a water-dampened soft, clean cloth. DO NOT use brass polish or household
cleaners as these products will damage the metal trim.
The motors used on the fan and the flame generator assembly are pre-lubricated for extended bearing life
and require no further lubrication. However, periodic cleaning/vacuuming of the fan/heater and air intake/
output vents is recommended.
Any other servicing should be performed by an authorized service representative.
To Next Page
Loading...
Need help?
General
