KINGSMERE 10' X 10' SINGLE-TIER SKYLIGHT GAZEBO 4
P
Before You Begin Assembly
arts List 6
13
14
S
Technical Data
tep-by-step Guide
Troubleshooting
38
37
Caring for Your Item
39
Warranty
40
TABLE OF CONTENTS
WARNING! To reduce the risk of serious injury, read the following
safety instructions before assembling and using the gazebo.
CAUTION! Always keep children and pets under close supervision
while they are using or around this product. Never leave children
unattended.
Let us help you!
DO NOT RETURN YOUR PRODUCT TO THE STORE. CALL US FIRST!
1-888-670-6684 (toll free).
If you have questions regarding your product , require warranty assistance,
o
r have damaged or missing parts, please call our customer service to
ll-free
helpline. Contact us for assistance; we’re here to help.
IMPORTANT: Please read and understand this manual before any assembly.
Before beginning assembly of product, make sure all parts are present. Compare
part
When assembling wooden parts, do not over-torque the bolts to avoid splitting
the wood. See image illustration.
s with packaging contents list. If any part is missing, or if you have any questions,
contact us at 1-888-670-6684 (toll free).
Place all parts from
the box in a cleared area and position them on the floor in front
of you. Remove all packing materials and place them back into the box. Do not dispose
of the packing materials until assembly is complete. Read each step carefully before
beginning any assembly and make sure you understand each step. If you are missing
a part, please call our
Customer Service team at
1-888-670-6684 (toll free).
TOOLS REQUIRED
Needed for assembly: Below tools are not included in the package.
Cordless drill
Hammer Ladder
people
Measure Distance
This identifies information
that requires special attention.
Improper assembly could
lead to an unsafe or
dangerous condition.
Square Assembly
Check that assembly is square
before tightening bolts.
Use Level
Check that set or assembly is
properly level before proceeding.
Tighten Bolts
Do not over-torque mounting bolts.
Over-tightening may cause the wood
to crack creating splinters and other
structural damage.
Screwdriver
NOTE:
Do not over-drill/
Be aware of over-drilling.
To Next Page
Loading...
Need help?
General
