Trailer Jockey Operators Handbook
69
639
{13}
SAE J1939 Multiplexing
Configuration Error - Out of
Calibration. The ECM
expected information from a
multiplexed device but only
received a portion of the
necessary information.
At least one multiplexed
device will not operate
properly.
91
{19}
SAE J1939 Multiplexed
Accelerator Pedal or Lever
Sensor System - Received
Network Data In Error. The
OEM vehicle electronic
control unit (VECU) detected
a fault with its accelerator
pedal.
Engine may only idle or
engine will not accelerate to
full speed.
974
{19}
SAE J1939 Multiplexing
Remote Accelerator Pedal or
Lever Position Sensor System
- Received Network Data In
Error. The OEM vehicle
electronic control unit (VECU)
detected a fault with the
remote accelerator.
The engine will not respond to
the remote throttle. Engine
may only idle. The primary or
cab accelerator may be able to
be used.
108
{2}
Barometric Pressure - Data
Erratic, Intermittent, or
Incorrect. The ambient air
pressure sensor is reading an
erratic value at initial key-on.
Engine power derate.
651
{5}
Injector Solenoid Driver
Cylinder 1 Circuit - Current
Below Normal or Open
Circuit. Current detected at
injector Number 1 when the
voltage is turned off.
Current to injector is shut off.
Engine can possibly misfire or
run rough.
655
{5}
Injector Solenoid Driver
Cylinder 5 Circuit - Current
Below Normal or Open
Circuit. Current detected at
injector Number 5 when the
voltage Is turned off.
Current to injector is shut off.
Engine can possibly misfire or
run rough.
Table 4-3 CM2150 System Fault Codes (Cont.)
Fault
Code Reason Effect
To Next Page
Loading...
