Caple CM465 - Rinsing the System

Instruction manual CM465
Please keep this instruction manual for future reference
25
9. Take out the water tank and fill it with clean water.
10. Put the water tank back in place. The display shows: “RINSING”.
11. Press the touch key ‘OK’ (9). A rinsing process takes place with clean water
and the rinsing water runs out of the hot water nozzle. After a few minutes
the water tank is empty and the display shows “RINSING COMPLETE PLEASE
CONFIRM”.
12. Press the touch key ‘OK’ (9). The display shows “DESCALE COMPLETE” and
then “FILL TANK!”
13. Take out the water tank, fill it with clean water and put it back in place.
The appliance is now ready for use again and is back to the last coffee mode
selected.
NOTE:
If the descaling cycle is interrupted before completion, the appliance continues
to display the descale message and the program must be started again from the
beginning.
Failure to descale the appliance invalidates the guarantee.
RINSING
If 2/3 minutes have passed, since you last made coffee, you should first rinse the
system to preheat the brewing unit. Select the rinsing function from the appropriate
menu. Let the water run into the drip tray underneath. You can also use this water
to warm up the cup that you are using for the coffee. In this case simply let the hot
water run into the cup (and then empty it).
1. Press the touch key ‘RINSE’ (4).
2. The appliance performs an automatic rinse cycle (a little
hot water runs out of the spouts and is collected in the
drip tray beneath).
MENU
EXIT
OK
4
CM465 Coffee Machine Instruction manual.indd 25 17/08/2017 13:59