Instruction manual DD610BK
47
Please keep this instruction manual for future reference
FLUSH INSTALLATION:
Glue the sealing tape onto the
corner of the supporting edge of
the worktop so that no silicone
adhesive can be pressed under
the hob.
Place the hob into the worktop
cut-out without any adhesive and
align it. Use shims if necessary.
Fill the gap between the hob and
the worktop with heat-resistant
silicone adhesive.
Minimum distance to adjacent walls
Cutout dimensions
Flush mount dimensions
IMPORTANT:
Silicone adhesive must not get under the support surface. If this occurs it will not be possible to
remove the hob again at a later stage. No liability will be assumed in the case of failure to observe
these instructions.
Minimum distance to adjacent walls
Opening dimensions
Cutout dimensions
Outer dimensions of the hob
IMPORTANT:
There is a risk of breakage if the hob is canted or sub-jected to stress during installation.
2
Insert the hob and align it.
OVERLYING INSTALLATION
750+1
min.50
500+1
520
800
1
1
2
24
4
R5 4
min.50
4,5 -0,5
To Next Page
Loading...