What to do if pressure on Carbon Zapp Industrial Equipment screen gauge is erratic?
If the pressure on the screen gauge is erratic and no actual pressure is present, it could be due to the software being in DEMO mode. Try reconnecting power to the machine. Also, check the USB connection.
What to do if Carbon Zapp Industrial Equipment shows Short Circuit / Open Circuit / Short to Ground?
If the Carbon Zapp Industrial Equipment indicates a Short Circuit, Open Circuit, or Short to Ground, it could be due to a wrong injector profile selected. Ensure the correct component is selected. Another possible cause is a damaged cable, which would need replacement. It could also be due to a damaged injector.
What to do if Carbon Zapp CRU.4R Industrial Equipment cannot reach TP pressure?
If the Carbon Zapp Industrial Equipment cannot reach the required TP pressure, ensure there is enough liquid in the tanks and that enough compressed air is going into the machine. Also, make sure the hydraulic system is free of air. As a next step, use the provided plug to eliminate a failing injector as a factor. If the pressure issue persists, contact your service provider.
General| Brand | Carbon Zapp |
|---|---|
| Model | CRU.4R |
| Category | Industrial Equipment |
| Language | English |
Symbols used for warnings and safety instructions in the manual.
Description and intended use of the CRU.4R unit.
Instructions for installing the unit on a bench.
Guide for connecting the unit's power supply.
Guide for connecting compressed air supply to the unit.
How to connect external attachment units to the main unit.
Pre-operation checks and setup.
Procedure for fitting injectors/pumps to the unit.
Steps for cleaning and testing injectors.
Step-by-step guide for performing tests.
Routine checks and tasks for unit upkeep.
Procedure for calibrating the RDS system.
To Next Page
