Cardiffair 900 Vantage User Manual

COOLING AUSTRALIAN’S FOR OVER 30 YEARS
FAN, MOTOR & LOUVRE
INSTALLATION
MANUAL
Cardiffair is a proud member of the HIA and is an
active company in the HIA Greensmart Program
Cardi Air Control Systems Pty Ltd
Family owned and operated
Unit 3, 28 Cavendish Road, Coorparoo Qld 4151
PO Box 1541, Coorparoo DC, Qld 4151
Ph 1800 800 943
Fax (07) 3394 1098 | Email sales@cardiffair.com.au
www.cardiffair.com.au

Cardiffair 900 Vantage Specifications

General

Model	900 Vantage
Voltage	220-240V
Frequency	50 Hz
Warranty	2 Years
Diameter	900 mm
Air Delivery	210 CMM

Summary

Fan Assembly

Tools and Box Contents

Lists required tools and details the fan's box contents for assembly.

Bend Bar Installation

Guides on identifying, positioning, and securing bend bars for the fan assembly.

Bearing Housing and Fan Mounting

Steps for installing the bearing housing and mounting the fan securely.

Tightening Sequence and Dampers

Details the correct bolt tightening order and installation of rubber dampers.

Motor Installation

Tools and Motor Preparation

Lists tools and describes removing the motor from its box.

Motor Mounting and Belt Setup

Instructions for mounting the motor and setting up the V-belt drive.

Speed Sensor Installation

Guides for installing the speed sensor disc, coil, and bracket.

Control Box Setup and Wiring

Explains connecting sensors, setting fan size, and wiring for the control box.

Louvre Actuator

Louvre Actuator Parts Identification

Lists and identifies the components of the Louvre Actuator assembly.

Assembly to Louvre Panel

Step-by-step guide to attaching the actuator assembly to the Louvre Panel.

Connecting Arm Installation

Correctly installing the connecting arm between the actuator and the motor.