Cardinal Gates door lock - User Manual

Install one-way stop bracket (I) on one side of
latch if you wish to have gate open in only one
direction.
A
B
C
D
E
F
G
H
I
1
6½
A
C
2
C
3
REPEAT AT
BOTTOM OF
GATE
2X
D
4
B
E
H
5
LOOSEN AT TOP AND
BOTTOM OF GATE TO
ADJUST GATE WIDTH
2X
F
6
MOUNT LATCH
ASSEMBLY WITH
SCREWS
4X
½
G
C
ONE-WAY
STOP BRACKET
OPTION
ASSEMBLY INSTRUCTIONS
1. Install hinge
bracket (A) to wall
(stationary side of
gate) using Phillips
screw (C)
beginning 6½
above floor
surface.
(Use ruler on left
edge of this sheet
to measure from
floor)
2. Install second
screw (C) in
top of hinge
bracket
securing it to
the wall.
THIS SIDE OF GATE HAS THREE (3) HOLES
3. Insert eye bolts (D) into top and bottom
of hinge side gate (side with three holes).
Be sure nuts are tight.
4. Hang gate by inserting hinge rod (B), through top
of mounted hinge bracket (A), through upper plastic
shoulder washer (E), through both eye bolts, through
lower plastic shoulder washer (E), and finally through
bottom of hinge bracket. To secure hinge, insert
key ring (H) through hole in end of hinge rod.
5. Use Allen wrench (F) to unscrew set screws on
top and bottom of gate to extend gate to fill door
opening. ONLY LIGHTLY TIGHTEN AND LEAVE
SHIPPING TABS IN PLACE NOT TO MAR GATE
FINISH. You will remove shipping tabs during final
tightening.
6. Hold latch assembly (G) against opposite
wall and extend gate until at least ½ of
safety bracket will interlock with flange
of latch. Mark position of latch assembly
screw holes with pencil. Swing gate out
of way and mount latch assembly to wall.
Check closure of gate and tighten set
screws from STEP 5 by removing shipping
tabs to secure gate width.
GATE IS RECOMMENDED FOR CHILDREN UP TO 24 MONTHS.
MG15 Auto-Lock Gate
I

Summary

Assembly Instructions

Install Wall Brackets

Securing the gate to the wall using provided screws and brackets.

Prepare Gate for Hanging

Inserting eye bolts into the gate for hinge attachment.

Hang Gate and Adjust Width

Attaching the gate to the wall bracket and adjusting its width.

Mount Latch Assembly

Installing the latch mechanism on the opposite wall for secure closure.

Optional One-Way Stop Bracket

Instructions for installing a bracket to restrict gate opening direction.

Product Safety Warning

Crucial safety information regarding gate installation and use for children.

Gate Maintenance

Cleaning and Care Recommendations

Guidance on cleaning the gate and protecting it from corrosion.

Gate Care & Reminders

Usage Tips and Safety Reminders

Advice on proper gate operation, safety, and periodic checks for security.

Gate Warranty

Warranty Terms and Conditions

Details the manufacturer's warranty period and coverage for defects.

How to Exercise Warranty

Steps required to claim warranty service, including required documentation.

Customer Support Contact

Information for obtaining further assistance and contacting the manufacturer.

Cardinal Gates door lock Specifications

General

Brand	Cardinal Gates
Model	door lock
Category	Door
Language	English