Cardinal 201 - INSTALLATION; Site Preparation Requirements

8400-0145-2M Rev A  201 PC Connectivity Setup Guide
3
29. The display will show:
30. Press F3. If the number shown is “000” press F3 to accept the value. Otherwise follow
the same process as in step 22 to set the value to “000”. Press F3.
31. The display will show:
32. Press F3. If the number shown is “000” press F3 to accept the value. Otherwise follow
the same process as in step 22 to set the value to “000”. Press F3.
33. The display will show:
34. Press F3. If the number shown is “000” press F3 to accept the value. Otherwise follow
the same process as in step 22 to set the value to “000”. Press F3.
35. The display will show:
36. Press F3. If the number shown is “000” press F3 to accept the value. Otherwise follow
the same process as in step 22 to set the value to “000”. Press F3.
37. The display will show:
38. Press F3. If the number shown is “000” press F3 to accept the value. Otherwise follow
the same process as in step 22 to set the value to “000”. Press F3.
39. The display will show:
40. Press F3. The display will flash or. If it is not showing on press F2 to toggle the
selection to on. Press F3 to accept the setting.
41. The display will show:
42. Press F3. If the number shown is “80” press F3 to accept the value. Otherwise follow
the same method as used in previous steps to change the value to “80” and press F3.
43. The display will show:
44. Press F3. The display will flash or. If it is not showing no press F2 to
toggle the selection to no. Press F3 to accept the setting.
45. Press F1 and F2 to save the settings.
46. The 201 will reboot “StatiC” then “P1=192”, “P2=168”, “P3=1”, and “P4=22”. If the
startup does not appear like this repeat the steps to make sure the settings are correct.