www.obd2express.co.uk
least 10 megohms of impedance. Fuel and battery vapors are
highly flammable.
To prevent an explosion, keep all sparks, heated items and open
flames away from the battery and fuel / fuel vapors. DO NOT
SMOKE NEAR THE VEHICLE DURING TESTING.
Don't wear loose clothing or jewelry when working on an engine.
Loose clothing can become caught in the fan, pulleys, belts, etc.
Jewelry is highly conductive, and can cause a severe burn if it
makes contact between a power source and ground.
Use extreme caution when working around the ignition coil,
distributor cap, ignition wires and spark plugs. These components
create hazards voltages when the engine is running.
Keep a fire extinguisher suitable for gasoline/chemical/electrical
fires nearby
Keep the scan tool dry, clean, free from oil/water or grease. Use a
mild detergent on a clean cloth to clean the outside of the scan
tool, when necessary.
Do not drive the vehicle and operate the scan tool at the same time.
Any distractions may cause an accident.
To avoid damaging the scan tool or generating false data, make
sure the vehicle battery is fully charged and the connection to the
vehicle DLC is clean and secure.
Do not place the scan tool on the distributor of a vehicle. Strong
electro-magnetic interference can damage the scan tool.
To Next Page