Updated:
17/03/2010
Ver. 1.1
Eng
Pag.9/12
SERVICE ALLARMS AND SIGNALS
SERVICE ALARMS
SERVICE ALARMS DUE TO MALFUNCTIONING OR FAILURE PRODUCE A WARNING
SIGNALS ON THE DISPLAY BY MEAN OF THE SERVICE ICON
CAVITY PROBE
FAULT
In case of cavity probe faulty or malfunctioning display shows the error
signal rE and E0 (cavity probe S1 fault) alternately
The appliance works however and compressor starts are controlled by
time (15 mins is ON and 15 mins is OFF) until the fault is resolved. This
alarm signal is automatically restored when the faulty erased and the
probe replaced
During this time interval the service alarm icon flashes on display and an
acoustic signal is ENABLED
EVAPORATOR
PROBE FAULTY
In case of evaporator probe faulty or malfunctioning display shows an
error signal E1 (evaporator probe S2 fault).
This alarm signal is automatically restored when the faulty erased and
the probe replaced
During this time interval the service alarm icon flashes on display.
Acoustic signal is DISABLED
CONDENSER
PROBE FAULTY
(WHEN INSTALLED
ON BOARD)
In case of condenser probe faulty or malfunctioning display shows the
error signal SEr and E2 (condenser probe S3 fault) alternately
This alarm signal is automatically restored when the faulty erased and
the probe replaced
During this time interval the service alarm icon flashes on display.
Acoustic signal is DISABLED
CLEAN ALARM
If a probe is set as the condenser probe, the condenser temperature can
be monitored to signal the high temperature alarm, due to obstruction or
fouling
In this case a warning signal is visualized and display shows the error
signal CLn and the temperature measured by the condenser probe
alternately
Service alarm icon is flashing and the acoustic signal DISABLED
The clean alarm is reset to zero by pressing the Prg/mute button and
the service alarm icon cancelled on display
To Next Page
Loading...
