Carel pCOWeb - 2 INSTALLATION ON THE PCO CONTROLLER; 2.1 ASSEMBLY

pCOWeb +030220966 – rel. 1.1 – 12.12.2017 9
2 INSTALLATION ON THE pCO CONTROLLER
2.1 ASSEMBLY
Equipment required:
• a 3 mm flat-head screwdriver;
• a map of the installation (only when installing two or more pCOWeb devices);
• a pair of scissors.
Figure 2.a - pCOWeb and the accessories supplied
Figure 2.b - Removing the cover from the pCO controller
IMPORTANT: to avoid damage, before inserting pCOWeb, disconnect power to the pCO controller.
Figure 2.c - Inserting pCOWeb in the pCO controller
Figure 2.d - Securing pCOWeb with the cover
To remove the board from pCO, insert a screwdriver in the hole to the left of Ethernet connector and pull up as shown in
Figure
2.e.
Figure 2.e – Removal of pCOWeb from controller
IMPORTANT: Do not remove the board by pulling the Ethernet connector!
Figure 2.f – Do not pull up pCOWeb using the Ethernet connector