Carel PJ32S - Page 35

SOXJLQ
Cod. +030221881 rel. 1.0 - 11/02/2000 31
FRQWLQXHG 
G GHIURVWSDUDPHWHUV     

G type of defrost (0= heating element,1= hot gas,
2= water or element by time, 3= hot gas by time)
& 0 3 flag 0
G, interval between two defrosts F 0 199 hours 8
GW end defrost temperature F -50 +127 °C/°F 4
G3 maximum defrost duration or effective duration when G =2 or 3 F 1 199 min 30
G defrost at instrument on (0=no, 1=yes) & 0 1 flag 0
G defrost delay when the unit is turned on or from digital input ( $ or $ =4) & 0 199 min 0
G display off during defrost (0=no, 1=yes) & 0 1 flag 1
GG dripping time after defrost F 0 15 min 2
G alarm bypass time after defrost F 0 15 hours 1
G priority of defrost over compressor protection (0=no, 1=yes) & 0 1 flag 0
G display defrost probe temperature F - - °C/°F -
G& time basis (0=hours/min, 1=min/s) & 0 1 flag 0
$ DODUPSDUDPHWHUV     

$ alarm and fan differential & 0 +19 °C/°F 0
$/ low temperature alarm (indicates the maximum variation allowed in respect to the
Set Point). If set = 0 excludes the low temperature alarm
F 0 +127 °C/°F 0
$+ high temperature alarm (indicates the maximum variation allowed in respect to the
Set Point). If set = 0 excludes the high temperature alarm
F 0 +127 °C/°F 0
$G temperature alarm delay & 0 199 min 0
$ digital input configuration & 0 4 - 0
$ detection time delay for the alarm input ( $ = 1) & 0 199 min 0
) IDQSDUDPHWHUV     

) fan management: 0 = fans always on except specific phases (see parameters ) ,
) , and )G ); 1=fans controlled according to the temperature of the evaporator and
excluding the phases ) , ) , )G .
& 0 1 flag 0
) fan on temperature: if ) =1;
) is the fan ON Set Point (evapor. T < Set Point( ) ))
F -50 +127 °C/°F 5
) fans off with compressor off (0=no, 1=yes). & 0 1 flag 1
) fans off in defrost (0=no, 1=yes). & 0 1 flag 1
)G off in post dripping. F 0 15 min 1
+ RWKHUVHWWLQJV     

+ serial address 0 199 - 1
+ PJ32S 0=T op.; 1=S op. with defrost
PJ32C selection of alarm relay operation
0=alarm normally not energised, 1=alarm normally energised
& 0 1 flag 1
+ 0=buttons disabled; & 0 1 flag 1
+ only PJ32S 0=buzzer enabled 1=buzzer disabled & 0 1 flag 0
+ identification code (or model number) F -99 +99 10
(*)
W external parameter (used only for the external options) F -127 +127 - -
7DE

(*):parameter + can only be set using the serial connection and is always visible at level F.