6. When replacing the needle clamp, make
sure the needle bar is in its highest
position. Slide the clamp up onto the
needle bar until the top of the clamp.
Tighten the needle clamp fixing screw
clockwise with 1.5mm hexagon wrench.
Note:
5. To remove the individual outer needles,
loosen the needle fixing screw on the
needle clamp by turning the 1.5mm
hexagon wrench counter-clockwise and
remove the needle(s). Insert the new
needle(s) until the top of the needle
touches the top of the needle hole. Tighten
the needle fixing screw with 1.5mm
hexagon wrench by turning the hexagon
wrench clockwise.
4. Hold the needle clamp, lower it slowly and
remove it from the needle bar.
3. Loosen the needle clamp holder fixing
screw by turning the 1.5mm hexagon
wrench counter-clockwise.
2. Loosen the presser height adjusting screw
and take it off, remove the cloth presser.
1. turn the hand wheel until the needle bar is
at the highest position.
Note:
Changing the needle(s)
Use #S1037 needles for the needle felting
machine.
Do not use any other type of needles.
Caution:
#S1037 needles do not have a front or back,
therefore,you can insert the needle in any
direction.
When you change needle(s), unplug the power
cord from the wall outlet.
#S1037 needle is a very special needle and is
exclusive for the needle felting machine.
See your retailer for replacement needles.
4. Maintenance
7
Needle clamp
holder
Groove
(inside holder)
To Next Page
Loading...
