5.8. Memory – Displaying the last 99 Measurements
At the end of a measurement, this monitor automatically
stores each result with date and time. This unit stores
99 memories for each of two users.
Viewing the stored values
With the unit off, press the "M" button. The display
first shows "A", then shows an average of all measure-
ments stored in the unit.
Pressing the "M" button again displays the previous
value. To view a particular stored memory, press and
hold the “M” button to scroll to that stored reading.
Memory full
When the memory has stored 99 results for the selected
user, a new measured value is stored by overwriting
the oldest value.
Clear all values
If you are sure that you want to permanently remove all
stored values, hold down the "M" button (the instru-
ment must have been switched off beforehand) until
"CL" appears and then release the button. If you do not
want to clear the values, press the ON/OFF button. To
permanently clear the memory, press the "M" button
while "CL" is flashing.
Individual values cannot be cleared.
24
To Next Page
Loading...
