Assembling and Installing Your Gate
NOTE: You will notice a slight gap between the gate door latch and the
frame. This is not a defect. Your gate is a pressure mounted gate and
this gap will disappear once you tighten your gate in its opening.
STEP 1
Locate the (4) threaded spindle rods.
Rotate the adjustment wheels along
the threading, eliminating the gap
between the adjustment
wheel and the rubber foot.
ADJUSTMENT WHEEL
RUBBER FOOT
STEP 2
Insert the (4) threaded spindle
rods into the holes at each of
the four corners of the gate.
NOTE: The ends of the gate frame are not threaded. The threaded spindle
rods should slide into the end of the frame tubes without any resistance.
6 ENGLISH
To Next Page
Loading...
