Carp Royal Remote Controlled Bait Boat

Questions and Answers

K
kthompsonAug 1, 2025
What to do if the Carp Royal Remote Controlled Bait Boat motor doesn’t work when all powers are ON?
- W
  Wyatt BoyerAug 1, 2025
  If the motor of your Carp Royal Fishing Equipment doesn’t work, consider the following: * Check for strong signal interferences from communication facilities, power lines, or skyscrapers. * Replace the fuse, ensuring you use ONLY a 10 or 15 A fuse. * Inspect and reconnect any poorly connected wires inside the boat. * Check if the receiver is well connected: ensure the wire numbers correspond to the receiver numbers, the metal side of plugs face the smaller number on the Receiver, and try exchanging for a new receiver and performing Code Matching.
N
Nicole TuckerAug 7, 2025
What to do if Carp Royal Remote Controlled Bait Boat Fishing Equipment boat gives no response when all powers are ON?
- K
  Kyle BoydAug 7, 2025
  If your Carp Royal Fishing Equipment boat isn't responding when powered on, check that the batteries in the transmitter are correctly installed. Additionally, the R.C. may be faulty. In that case, return the entire R.C. set (including transmitter and receiver) to Carp Royal.
X
Xavier RussoAug 12, 2025
What to do if Carp Royal Remote Controlled Bait Boat Fishing Equipment motor runs by itself?
- M
  Miranda JacobsAug 12, 2025
  If the motor of your Carp Royal Fishing Equipment runs by itself, it may be due to signal interference or unmatched transmitter and receiver signals, same as described in No. 3. Also, the R.C. may be faulty. In that case, return the entire R.C. set (including transmitter and receiver) to Carp Royal.
J
Jacqueline TerryAug 25, 2025
Why Carp Royal Fishing Equipment transmitter buzzes intermittently?
- G
  Gregg TaylorAug 26, 2025
  The intermittent buzzing from your Carp Royal Fishing Equipment transmitter may be due to low battery power. Try changing to new batteries.
J
Jane WilliamsNov 18, 2025
How to fix R.C. giving no response with red LED on Carp Royal Remote Controlled Bait Boat?
- B
  Brad BrownNov 18, 2025
  If the R.C. of your Carp Royal Fishing Equipment isn't responding and the receiver LED is red, it could be due to signal interferences or unmatched transmitter/receiver signals. To resolve this: 1. Receiver: Turn on the Main Switch, press and hold the Set Key until the LED turns from red to flickering orange, then release. 2. Transmitter: Press and hold the Code Matching Key while turning on the Main Switch (LED Monitor will be green). Release and press the Code Matching Key again (LED Monitor turns orange). Then press and hold the key until the LED Monitor flickers orange. Check both LEDs. 3. If the Receiver LED is OFF and the Transmitter LED is green, code matching is complete. Release the key. 4. Turn off and on both the boat and transmitter to test. Ensure code matching is done in...