3. Place all switches in the upward position
Then push the power button upwards to turn on the
remote control.
Now push the left joystick briefly downwards (red
arrows) and as long as all switches are in the upward
position, the signal tone will stop, and the remote
control now has control of the boat.
4. In the display you can see the remaining volts left
on the battery´s of the remote control.
2.4.1 DESCRIPTION OF THE REMOTE CONTROL
The remote control has a few levers, switches and knobs of which only some are
stored with commands for the boat, and these are described here. The other´s have
no commands assigned to them.
To Next Page