carrarospray ATVM-ATV User Manual (English)

Questions and Answers:

N
Nicole TylerAug 2, 2025
Why is the pressure gauge fluctuating too much on my carrarospray Farm Equipment?
- A
  Anthony ZimmermanAug 2, 2025
  If the pressure gauge is fluctuating too much on your carrarospray Farm Equipment, it could be due to several reasons. First, the pump might be sucking in air through the inlet. To fix this, examine the suction hose and ensure it's firmly secured. Another possibility is that air hasn't been fully evacuated from the pump. Try running the pump with the outlet hose open to let the air escape. Also, check for locked valves, which may need cleaning or replacing, and inspect the gaskets for leaks, cleaning or replacing them if necessary.
J
James BrooksAug 7, 2025
How to fix a carrarospray Farm Equipment pump that does not suck in water?
- L
  lhardyAug 7, 2025
  If your carrarospray Farm Equipment pump isn't sucking in water, there are a few potential causes. One or more valves might not be seating correctly; in this case, examine the valve seats and clean them. Another issue could be a plugged or collapsed suction line, so inspect the suction line. Lastly, check for a clogged strainer and clean it if necessary.
P
petersonwarrenAug 11, 2025
What to do if oil gets out with the liquid in carrarospray Farm Equipment?
- E
  Elizabeth CrossAug 12, 2025
  If oil is getting mixed with the liquid or you see liquid mixed with oil in the sight glass of your carrarospray Farm Equipment pump, it likely means one or more diaphragms have split. To resolve this, drain the oil from the pump, dismantle the heads, and install new diaphragms. After that, refill the pump to the correct oil level using motor oil (SAE 20W40).
K
Kevin WeissAug 17, 2025
How to troubleshoot a carrarospray Farm Equipment pump that does not reach the pressure?
- L
  Leah WhiteAug 17, 2025
  If the pump on your carrarospray Farm Equipment isn't reaching the correct pressure, the seals on the pressure control valve may be worn or damaged. You should replace the seals and, if necessary, also replace the valve seat and the pin to fix this issue.