06 OPERATION
• Fill the cup with food between the MIN and MAX marks. Cover
the cup with the lid.
• Make sure that the speed control is positioned to 0.
• Connect the appliance to a mains power supply with appropriate
characteristics.
• Set the power switch to ON and turn the speed control to select
the speed mode. The selected speed indicator will light up. The
LED display will start counting down the operation time.
• When the desired consistency is reached, turn the speed control to
the 0 position and turn the power switch to OFF.
• Remove the cup from the base, then remove the lid and pour the
food out into a suitable container. Wash the cup, lid and blade with
warm water and mild detergent or perform automatic cup cleaning.
• Unplug the appliance if you do not plan to use it in the near future.
Pulse mode
Use the pulse mode to quickly chop coarsely chopped foods.
Without turning the power switch to the ON position, turn the
PULSE switch to the ON position and hold it there until the desired
result is obtained. Do not use the appliance in this mode for a long
time.
Ice crush mode
Use the mode to make ice chips: you can use them to make
cocktails, serve fish and seafood and to chill food. To crush ice, turn
the appliance on at speed . Do not attempt to crush more ice at
the same time than recommended in the table below.
WARNING!
To avoid overheating, do not run the appliance for more
than 3 minutes continuously. Take breaks of 10-15 minutes.
EN 6
To Next Page
Loading...