Carrier 38QUS018DS - Page 23

4
DISASSEMBLY INSTRUCTION
No.
Parts name Procedures Remarks
1 Remove the
filter
1) Open the grille
2) Remove the filter
Note: the filter is easy to be
damaged, be careful when
removing it.
2 Remove the
panel
1) Open the grille
Repeat the operation of step1 of No.1
2) Remove the grille
 Screw off two screws.
 Disconnect the display
board wire and swing
motor wire connected to
the PCB.
 Remove the grille.
3)
Loose the four screws
and two wireropes, then
the panel can be
disassembled.
3 Remove the
display
1) Open the grille
Repeat the operation of step1 of No.1
2) Remove the grille
Repeat the operation of step2 of No.2
Grill switch
2 screws
4 screws
2 wireropes
display board wire
s
wing motor wire