Carrier 38XTZ 007-024 - Page 38

38
Table 15 - Options/accessories
38XTZ-40ABZ/ALZ Option Accessory
Heating coils for 40ABZ/ALZ indoor units:
A - electric resistance heaters x x
B - hot-water coils xx
Thermal-magnetic crankcase heaters for 38XTZ outdoor units x x
Low refrigerant pressure switch for 38XTZ outdoor units* x -
Head pressure control for cooling operation at outdoor air temperatures below +19°C (38XTZ) x x
Special drives for higher indoor unit fan static pressure
(40ABZ/ALZ - installed in the units on request) x -
Room thermostat, wired remote control - versions:
A - 220 V for sizes 38XTZ 007 and 008 with 40ABZ 007 and 008
(one stage cooling, one stage heating) - x
B - 24 V for sizes 38XTZ 011 to 024 with 40ABZ/ALZ 011 to 024
(two stages cooling, three stages heating)
B1 - Programmable, with remote sensor option for return air duct or room air - x
B2 - Non programmable - x
From the Master Link I control, for sizes 38XTZ 016-024/40ABZ 016-024
A - Advanced service tool (via PC software)** - x
B - Interface converter, for control of up to 15 x 15 units via PC software** - x
C - Basic tool** -x
D - Communication board** - x
Accessories are not factory-installed.
Options can be ordered for factory-installation in the units, or they can be installed later.
* To be requested at time of order, installed in the 38XTZ units.
** - With the basic service tool the communication board must also be ordered.
-With the advanced service tool (via PC software) the communication board and the communication interface converter
must also be ordered.
- If an installation includes various units connected to a communication bus, all units on the bus must include the
communication board.