8
42PQV
Powerful (button F)
If you want more powerful capacity at Cooling, Dry and Heating
mode, press button . On the display, the powerful icon will
start flashing.
1.
Powerful at Cooling mode
Performs the powerful cooling operation
until room temperature reach 17°C or
20minuts after pressing Powerful button.
At this mode, indoor fan speed is high
and compressor speed is over rating
speed in order to obtain maximum cooling
capacity.
2.
Powerful at Heating mode
Performs the powerful heating operation
until room temperature reach 32°C or
20minuts after pressing Powerful button.
At this mode, indoor fan speed is high
and compressor speed is over rating
speed in order to obtain maximum
heating capacity.
3.
Powerful at Dry mode
Performs the effective dry operation
until room temperature in under 17°C or
3hours after pressing Powerful button.
At this mode, indoor fan speed is low
in order to remove humidity more
effectively.
During Powerful mode, you cannot control room temperature, and
fan speed.
Press one of the buttons , or E to cancel the powerful mode.
Economical E (button G)
If you want silent and mild operation at cooling, heating and Auto
mode, press button
E . On the display, the economical icon E will
start flashing.
1.
Economical at Cooling mode
Indoor fan rotates under low fan speed and
compressor speed is under rating speed.
2.
Economical at Heating mode
Indoor fan rotates under low fan speed and
compressor speed is under rating speed.
3.
Economical at Auto mode
Unit operates Economical cooling
mode or Economical heating mode
depending on room temperature.
During Economical mode, you can control room temperature and
flap position except fan speed.
Press one of the buttons , or
E to cancel.
Use of the remote control
ON timer procedure
1.
ON TIMER button (button I)
Press this button, even if the remote
control is OFF. The relevant icon and
time figure will start to flash.
If 10
seconds
have elapsed and no
button is pressed,
the remote control
turns OFF (if it was already OFF when
button was pressed) or timer function
automatically deactivates.
2.
HOUR/MINUTE buttons
(buttons and )
If the unit is ON, the only possible
selection is the start-up time.
The unit will operate with the selections
shown on the display.
3.
HOUR/MINUTE buttons
(buttons and )
If the unit is OFF: to select the start-up
time, use the temperature cotrol buttons
(buttons and ).
First select the
hours
and, afrer have
confirmed these by pressing
button ,
select the minutes using either button
or .
To definitively set the time, press button
again.
4.
Operating mode
Choose the unit operating mode.
The icons will flash.
To select the mode, use the button .
Once the mode has been decided, press
button . The icon of the selected mode
will stop flashing.
5.
Desired temperature
To select the desired temperature,
(the
value is flashing, use either button
or .
Push button , to confirm the
selection.
Numbers will stop flashing.
6.
Fan speed
Choose the fan speed, using button .
When the selection has been completed
,
press button for confirmation.
The icon will stop flashing.
7.
Louvre positioning
Now this icon is flashing.
Use button , to select desired position.
Press button for confirmation.
Now all
i
cons are fixed on display.
If you want to cancel selections up to here
inserted, push button ; if you want to
cancel all options once timer has been
set, push button and then
.
To Next Page
Loading...
