GB - 5
ENGLISH
STAND-ALONE
Preparation for:
dehumidification
STAND-ALONE
Preparation for:
fan only
STAND-ALONE
Preparation for:
heating
Maintain the flexible hose with the shortest length and bend it so that the air flow coming out
from the air conditioner is perpendicular to the floor.
If the air conditioner is to be used in the fan only mode (ventilation) the
flexible hose should be inserted with the shortest length and bend so
that the air flow coming out from the air conditioner is perpendicular to
the floor.
To empty the tank, switch the unit off
and remove the plug from the power
supply socket.
Take out the full water tank on the rear of
the unit and empty it.
Then replace it correctly in its position.
In certain applications, when a floor drain
may be available it may be easier to use
the drain tube to remove the condensate
water directly.
Proceed as follows:
• Pull out the 60 mm long condensate
drain tube and remove the plug.
• Connect the drain tube to the floor
drain using a rubber tube.
After use remember to put the plug
into the drain tube and to replace the
tube in its position.
To Next Page
Loading...
Need help?
General
