18
NOTE: The alarm will mount to the bracket in 4 positions (every 90 degrees).
• Turn on the AC power. The green AC Power On Indicator should be lit when the alarm is operating from AC power.
NOTE: Attaching AC power first, without removing the battery pull tab, will result in a false low battery
trouble condition chirp (see Troubleshooting Guide). You need to activate the batteries to eliminate
the false low battery trouble condition chirps. Remove the battery pull tab to avoid false low battery
notification.
AC Wired Interconnect Model Capability
This model has AC hardwire interconnect capability. When one hardwired interconnect unit sounds an alarm,
all other compatible hardwire or interconnected units will also alarm. NOTE: AC wiring must be completed
properly and the AC quick connector must be attached to the unit for the hardwire interconnect function to work.
The following models can be interconnected using the standard AC wiring interconnect: i12020, i12020A,
i12040, i12040A, i12060, i12060A, i12080, i12080A, i4618, i4618A, i4618AC, KN-SMFM-I, RF-SM-ACDC, PE120,
P12040, Pi2000, Pi2010, KN-COSM-I, KN-COSM-IB, KN-COSM-IBA, KN-COPE-I, KN-COPE-IC,
KN-COB-IC, KN-COP-IC, SL177i, SLED177i, HD135F, SM120X, CO120X, i12010S, i12010SCO,
P4010ACSCO, P4010ACSCO-W, P4010LACS-W, P4010ACS, P4010ACS-W, P4010ACLEDS-2,
P4010ACLEDSCO-2, 3050-VAS10-A, 3050-VASC10-A, P4010ACSCO-WF, P4010ACSCOAQ-WF, 900-CUAR,
900-CUAR-V.
The alarm is now activated! After installation / activation, test your alarm as described in Operation and Testing
section.
WARNING: Failure to properly connect AC power and install batteries in the correct orientation will
prevent proper operation of this alarm and will prevent its response to fire hazards.
To Next Page
Loading...