12
10. Reattach the upper part of the Wi−Fi translator to the back plate. After
re−attaching the upper part avoid clamping the wiring during installation.
Fig. 24 - Reattaching the upper part of the Wi−Fi translator
11. Re−install the control box cover on the indoor unit.
12. Power up the system
13. Using the supplied Wireless Remote controller, set the unit in AP mode pointing
it out to the Infrared receiver of the indoor unit. (For the Ducted units, the
infrared receiver is located inside the Control box of the indoor units.)
14. Complete the app setup instructions found in the Owner’s Manual.
NOTE: The Wi−Fi kit comes with an additional QR sticker. It is suggested to adhere this
sticker to the fan coil in a customer approved location while allowing it to be seen during
the app installation.
To Next Page
Loading...
